The ASE A6 Electrical/Electronic Systems Test is 1.5 hours long and has 60 (50 scored) multiple choice questions in the following categories:
- General Electrical/Electronic System Diagnosis – 13 questions
- Battery & Starting System Diagnosis & Repair – 9 questions
- Charging System Diagnosis & Repair – 5 questions
- Lighting Systems Diagnosis & Repair – 6 questions
- Instrument Cluster & Driver Information Systems Diagnosis & Repair – 6 questions
- Body Electrical Systems Diagnosis & Repair – 11 questions
Make sure you are prepared for your ASE A6 Electrical/Electronic Systems. McRee Learning Center can help.
ASE A6 Electrical - Sample
0 of 10 questions completed
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 10 questions answered correctly
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Thanks for completing your free sample quiz. Make sure you pass your ASE 6 Exam the first time. Take the full U Test Prep Exam today to achieve your highest possible scores and reach your goals.
Purchase now and pass the first time!
Question 1 of 10
An alternator overrunning pulley (AOP) is being tested with the accessory drive belt removed. It is functioning correctly if________.CorrectIncorrect
Question 2 of 10
What type of problem is indicated by a lower than normal amperage reading when a circuit is activated?CorrectIncorrect
Question 3 of 10
This question is not like the ones above. It has the word LEAST. For this question, look for the choice that would LEAST LIKELY cause the described situation. Read the entire question carefully before choosing your answer. An alternator has low output and is being full-fielded to determine the cause. Which of the following is the LEAST likely result of full-fielding the alternator?CorrectIncorrect
Question 4 of 10
The cigar lighter requires repeated fuse replacements. The cause of this problem could be:CorrectIncorrect
Question 5 of 10
A short in the ground may be identified by connecting a ______ in place of the circuit fuse.CorrectIncorrect
Question 6 of 10
Which of the following reduces friction between a stationary and rotating part?CorrectIncorrect
Question 7 of 10
Which of the following is the LEAST likely cause of a dim headlight?CorrectIncorrect
Question 8 of 10
A circuit breaker is removed from a functioning power seat circuit, and an ohm-meter is connected to the circuit breaker terminals. Technician A says the ohmmeter should provide an infinite reading if the circuit breaker is satisfactory. Technician B says the ohmmeter current may cause the circuit breaker to open. Who is right?CorrectIncorrect
Question 9 of 10
The high beam indicator on the dash does not come on but both headlight beams work. Technician A says that the indicator bulb could be defective. Technician B says the dimmer switch could be defective. Which technician is correct?CorrectIncorrect
Question 10 of 10
Which of the following describes the MOST common type of electrical wiring used in instrument lighting?CorrectIncorrect