The ASE A3 Manual Drive Train and Axles Test is 1 hour long and has 50 (40 scored) multiple choice questions in the following categories:
- Clutch Diagnosis & Repair – 6 questions
- Transmission Diagnosis & Repair – 7 questions
- Transaxle Diagnosis & Repair – 7 questions
- Drive Shaft/Half-Shaft & Universal Joint/Constant Velocity (CV) Joint Diagnosis & Repair (Front & Rear Wheel Drive) – 5 questions
- Four-Wheel Drive/All-Wheel Drive Component Diagnosis & Repair – 8 questions
Make sure you are prepared for your ASE A3 Manual Drive Train & Axles. McRee Learning Center can help.
ASE A3 Manual Drivetrains and Axles - Sample
Quiz Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Thanks for completing your free sample quiz. Make sure you pass your ASE A3 Exam the first time. Take the full U Test Prep Exam today to achieve your highest possible scores and reach your goals.
Purchase now and pass the first time!
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
During manual transmission removal and replacement:
CorrectIncorrect -
Question 2 of 10
2. Question
Premature wear in the extension housing bushing will most likely be caused by:
CorrectIncorrect -
Question 3 of 10
3. Question
Bearing preload is:
CorrectIncorrect -
Question 4 of 10
4. Question
All of the following problems may cause a vibration on a four-wheel drive (4WD) vehicle that is more noticeable when changing throttle position EXCEPT:
CorrectIncorrect -
Question 5 of 10
5. Question
The shift lever adjustment is usually performed with the transmission in:
CorrectIncorrect -
Question 6 of 10
6. Question
In a manual transmission, the reverse idler gear is in mesh with what gear only?
CorrectIncorrect -
Question 7 of 10
7. Question
The most likely cause of clutch chatter among the following is:
CorrectIncorrect -
Question 8 of 10
8. Question
While discussing a four-wheel drive vehicle with a vibration problem that is more noticeable while corning, Technician A says that the U-joints may be worn. Technician B says that the outboard front axle joints may be worn. Who is right?
CorrectIncorrect -
Question 9 of 10
9. Question
A transmission has a growling noise in first gear only. The cause of the problem could be:
CorrectIncorrect -
Question 10 of 10
10. Question
All of the following statements about limited slip differentials are true EXCEPT:
CorrectIncorrect